Teroson Marine Glass Fibre Filler  £11.00

Technical Data: (Typical Test Results)

Component A:

• Colour - Blue.
• Odour - Styrene.
• Density - Approx. 1.82 g/cm³.

Component B:

• Colour - Red.
• Odour - Neutral.
• Density - Approx. 1.1 g/cm³.

Mixture (Component A+B):

• Mixing ratio by volume - 100: 2-3.
• Pot life (20 °C, 50% rh) - 6.5 min.
• Grinding - Possible after 20 to 30 min

Pre-Treatment:

• The surface area around the dent, scratch or hole must be clean, dry and free from oil, grease and loose particles.
• In case of rusty surfaces, the rust has to be removed to bare metal.
• The entire repair area should be grinded with 120 grit sandpaper.
• It is not necessary to remove the paint around the repair area, as long as the paint has good adhesion to the surface.
• Finally, the sanded parts have to be cleaned and pretreated for the next step with TEROSON VR 20

Application:

1. Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) with a 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved.
2. After mixing the time to apply the filler is approximately 6.5 minutes at 20°C.
3. Apply the filler mixture onto the repair area in a way that the dent, scratch or hole is sufficiently filled.
4. Thicker layers should be built up using multiple layers.Surface can be sanded after 20 to 30 minutes at room temperature.
5. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application.