This item is classed as a HAZARDOUS PRODUCT and has delivery/courier restrictions. Unfortunately, delivery cannot be made to addresses outside the UK and cannot be made to those with the following GB postcode prefixes: BT1-BT99, GY, IM, JE, KA27, PO30-PO41, TR21, TR25.
Before you apply it:
The surface should be stable, firm, dry and free of dust, sand, loose old paint, dirt, grease, oil and salt.
Abrade any new bare GRP with 180-220 grit, removing residual hull release agent.
Ensure steel is free of rust (grit blast where possible)
Ensure wood is dry and sound
Ensure ferro-cement, lead and aluminium are free of corrosive deposits and lightly abraded.
Previously antifouled surfaces in good condition: remove any loose material and lightly abrade using plenty of fresh water.
How to apply it:
Stir product well before use.
Apply 1 or 2 coats by roller, brush, or spray allowing 3-6 hours between coats depending on temperature.
If a filler is necessary, apply 1 coat of primer first.
Area of Use
Boat hulls, topsides and superstructure
Substrates
GRP, wood, steel, and ferro-cement.
Packing
1 Litre / 2.5 Litres
Colour
Grey
Finish
Matt
Volume solids
60%
Theoretical Spreading Rate
12 sq. metres per litre *
Flash point
42 degrees Celsius
Specific gravity
1.17
Dry to touch
2 hours
Over-coating time
6 hours
* The coverage has been calculated for the stated volume solids and dry film thickness. A practical spreading rate will depend on the actual dry film thickness, the nature of the substrate, and the relevant consumption factor. The physical constants are subject to normal manufacturing tolerances.
There are 7 reviews with an average rating of 4.85
I found Gael Force service Ecellent fast post . The Multi purpose primer gave good coverage and good value for money Must say i recomend there Antifuling got two years out of it so on it gose again this winter ..Eric J Butler
Staff went out of there way to obtain from another store when not in stock. Applied at the start off the week went on really well will see how it lasts with the antifoul for a 26ft bilge keel yacht.
I used this on my Redshank dinghy custom made floorboard and it went on like a dream. Extremely good finish and coverage. Used roller and brush. Dried to a superior surface to accept top coat of gloss.
.jpg)
